Search
0
Shopping Cart
Choose!

Y-Cables Set Iveco diagnostic cable set for Daily Euro 5 + 6 engines

Iveco diagnostic cable set for Daily Euro 5 + 6 engines, complete set with 14 Y-cables plus 18 pin plastic breakout box 574210018.

A Y-cable or splitter cable is placed between the sensor/actuator and harness connector to allow the sensor to function normally in a working engine management system. By connecting the 18 pin breakout box to this cable, a measurement of the signals from and to the sensor can be carried out in a safe and reliable manner. This can be done by using a multimeter or scope. The pin assignment with the pin numbers on the connector is equal to the number of numbers on the breakout box. In this way, it is no longer necessary to pierce cables to measure a signal. The use of a paper clip and measuring along the seals is therefore a thing of the past. This prevents a hole in the insulation of the wire or the seal and the copper of the wire cannot oxidize and cause problems in the future. It will also no longer be necessary to measure in a loose connector with the risk of damage to the contact. And moreover, the sensor no longer works with a loose connector!

14 Y-cables for 26 sensors / actuators:

# Sensor / Actuator # Sensor / Actuator
1 M-prop 14 EGR actuator
2 Camshaft sensor 15 Common rail pressure sensor
3 Glow relay 16 Inlet manifold valve
4 Inlet pressure sensor 17 Fuel injector
5 Oil pressure sensor 18 Common rail press. reg. valve
6 Oil temperature sensor 19 PWM variable geometry turbo
7 Trubo actuator 20 Glow plugs
8 Exhaust brake actuator 21 Oil pressure switch
9 Carter pressure 22 Turbo speed sensor
10 AC clutch 23 Coolant temperature sensor
11 Radiator fan clutch 24 Fuel filter temperature
12 Cylinder head conn. for fuel injectors 25 Diff. pressure sensor
13 Acutator variable geomotry turbo 26 Engine oil level

Write a review

Note: HTML is not translated!
    Bad           Good

Do you have any questions about Y-Cables Set Iveco diagnostic cable set for Daily Euro 5 + 6 engines?